Using the HP DTC Manager/UX

181
A
DTC terminal user commands
This appendix explains:
• the configuration parameters that affect the DTC terminal user interface
• the commands that you can use from a terminal connected to a DTC
Type help at the DTC prompt to see a list of the available terminal user commands.
DTC terminal user interface parameters
The following parameters are related to the DTC terminal user interface.
• Switching—Only terminals which have switching enabled are connected to the
DTC terminal user interface. If switching is disabled, from a terminal you are
connected directly to the system and do not see the DTC prompt.
• Welcome message— This message is displayed when you try to logon from a
terminal or when you use the status command. The welcome message is
explained on page 70.
• User prompt—This prompt is displayed when you try to logon from a terminal.
It is at the user prompt that you enter the DTC terminal user commands. The user
prompt is explained on page 70.
• Escape from data transfer character— After connecting to a system, you can
return to the DTC terminal user interface by using the Escape from Data Transfer
character. The default is Ctrl K (^k). If you are in binary mode (see page 183),
use the Break key. The escape from data transfer character is explained on
page 96.
• Default destination— If a default destination system has been defined for the
port, then you can enter the DTC connect command without specifying a system.
You are automatically connected to the default destination system.