Using the HP DTC Manager/UX

183
DTC user interface commands
A
Note The DNS must be up and running at the boot time of the DTC.
Disconnect Closes the system connection. Each connection is identified as a number (xx) in the
status command display. Only the connection number can be used. The connection
name cannot be used. If the connection number is not specified, the current system
connection is closed.
D[ISCONNECT] [ xx ]
Help or ? Displays a list of available commands, their abbreviations, and a brief explanation.
H[ELP]
Logout Logs you out of the DTC user interface. If the connection is via modems, the line is
dropped. If the connection is open on a system, it is closed.
L[OGOUT]
Recall Resumes a connection that you left open when you used the escape from data
transfer character to leave a connection without logging off.
R[ECALL] [ xx ]
Each connection is identified as a number (xx) in the status command display. Only
the connection number can be used. The connection name can not be used. If the
connection number is not specified, the specified system connection is recalled.
Set ASCII Sets the data transfer mode to ASCII.
[SET ]A[SCII] [ xx ]
Each connection is identified as a number (xx) in the status command display. Only
the connection number can be used. The connection name can not be used. If the
connection number is not specified, the specified system connection is set.
Set Binary Sets the data transfer mode to binary.
[SET ]B[INARY] [ xx ]