Using the HP DTC Manager/UX

82
Configuring DTC management protocol parameters
7
Configuring DTC management protocol parameters
The Configure DTC Management Protocol Parameters screen is used to specify
DTC timing information for different LAN configurations.
1 Place an x or X to choose the set. The parameter values are defined according to
the set that you choose. These values are shown in table on the following page.
2 Set 1—HP default. Parameters designed for traffic over a LAN only.
Set 2—Parameters designed for traffic over a LAN with bridges.
Set 3—Parameters designed with alternative values for traffic over a LAN with
bridge.
3 When you have finished entering values, press the Done (F4) function key. You
are returned to the Rear Panel Configuration screen.
4 The DTC management parameters can not be modified dynamically. Exit from
dtcconfig and reset the DTC by executing the following command at the shell
prompt:
dtcreset
dtcname
tsta195:root:/opt/dtcmgr/sbin
DTC Configuration Main Menu
Highlight an item and then press “Return” or “Select Item” (F4).
Add DTC Configuration ..
Modify DTC Configuration ....
Delete DTC Configuration ...
Modify Default Parameters ->
Help for Using DTCconfig
Help
Shell
Select
Item
tsta195:root
Exit
DTCconf
DTC NameClick here, or press F1 for online help
Rear Panel Configuration
Action Menu (F5)
Configure DTC Management
Board = C or L
Protocol Parameters