Using the HP DTC Manager/UX

86
Configuring the port type
8
The steps are as follows:
1 Enter the board and port numbers at the Rear Panel Configuration screen.
2 Press the Action Menu (F5) function key and select Change Port Type.
The Change Port Type screen appears.
3 Indicate a printer or terminal port type by entering an x or X in the appropriate
field and press Return or the Done (F4) function key.
Note Change Port Type copies in the default port settings for the specified port type
(terminal or printer) when it is used. Therefore, any data that was in the port
configuration will be lost.
4 You can configure another board and port or exit from this Rear Panel
Configuration screen.
The Change Port Type screen
tsta195:root:/opt/dtcmgr/sbin
Rear Panel Configuration
Fill in the DTC 72MX board and port fields and then press “Action Menu” (F5).
Help
tsta195:root
Exit
Window
Board (L = LAN, or 0 - 3 = - board): Port (0 - 23):
Board 0
Board 1
Board 2
0 T 2 T 4 T1 T 3 T 5 T
Board 3
8 T 9 T 10 T
6 T 7 T DIRECT
11 T 12 T 13 T 14 T 15 T
DIRECT
DIRECT
DIRECT
DIRECT
DIRECT
16 T 17 T 18 T 19 T 20 T 21 T 22 T 23 T
0 T 2 T 4 T1 T 3 T 5 T
8 T 9 T 10 T
6 T 7 T
11 T 12 T 13 T 14 T 15 T
16 T 17 T 18 T 19 T 20 T 21 T 22 T 23 T
Done
Change Port Type
wally board 1 port 19
Mark with an “x” the type of port to configure.
Then press “Return” or “Done” (F4).
x
Terminal Printer
19
1
Action Menu
Configure Port Parameters ...
Enable Port Options ...
Copy
Paste
Change Port Type ...