WU-FTPD 2.6.1 Release Notes (September 2008)

— EPRT - Extended Port
This command specifies a host port for both IPv4 and IPv6 connections.
Example 1-10 ERPT Command Output for IPv6 and IPv6 Connections
The following displays the output for the EPRT command for both IPv6 and
IPv6 connections.
For IPv4:
------> EPRT 1 132.235.1.2 50934
For IPv6:
------> EPRT 2 fe80::260:b0ff:fec1:7b2f 50934
— EPSV - Extended Passive
This command requests a server to listen on a data port and wait for a
connection. The response to this command includes only the TCP port number
of the listening connection.
Example 1-11 EPASV Command Output
An example for the EPASV command is as follows:
ftp> passive
Passive mode on.
------> EPSV
229 Entering Extended Passive Mode ( 9495 ).
• Implementation of RFC 1639 (FTP Operation Over Big Address Records (FOOBAR))
This RFC describes a convention for specifying an address other than the default
data port for the connection over which data is transferred.
The commands to accommodate FTP operations over network and transport
protocols are specified as follows:
— LPRT
This command allows you to specify a long address for the transport connection.
Example 1-12 LPRT Command Output
The following displays the output for the LPRT command:
------> LPRT6,16,254,128,0,0,0,0,0,0,2,96,176,255,254,193,123,47,
2,198,244200 LPRT command successful
WU-FTPD 2.6.1 Features 27