HP-UX 11i v3 Read Before Installing or Updating, March 2009 (Update 4 Release)

After DRD Update is Performed on a Clone, You May See Errors
During swverify
Dynamic Root Disk (DRD) now supports doing updates from an earlier
version of HP-UX 11i v3 to the HP-UX 11i v3 March 2009 release on the
clone while the active system is up and running. You can run this on a
stand-alone machine, on virtual machines (VM), or on nPars. After the DRD
update is performed on the clone, you may boot from the clone disk and
run a swverify \* to ensure the software was updated correctly. On a
virtual machine or an nPar, you may see these errors during the swverify
of the software:
ERROR: Failed to create the EMT database.
ERROR: Could not install the EMT database. EMT configure failed.
ERROR: The "configure" script for "SFM-CORE.EMT_COREIA" failed
(exit code "1"). The script location was
"/var/adm/sw/products/SFM-CORE.2/EMT_COREIA/configure".
What to Do
For a work-around or additional steps that need to be taken to successfully
configure System Fault Management (SFM, SysFaultMgmt), check the known
problems and issues at the DRD website: http://docs.hp.com/en/DRD/.
At End of Update, DRD Recommends a Non-Functional Feature
At the end of an update, Dynamic Root Disk (DRD) recommends that you
run swm job log -v <job_id>. However, this feature is not functional
and could produce a stack trace.
What to Do
To view the log on the inactive image, run this command instead:
Known Problems 27