HP Fortran Programmer's Guide (B3908-90031; September 2011)

Compiling and linking
Compiling with the f90 command
Chapter 254
Control the generation of source position information for the Caliper analysis tool.
When +srcpos is in effect (the default), the compiler generates this information.
When +nosrcpos is in effect, the compiler does not generate this information, and the
compiler will instruct the linker to discard any of this information encountered in object
files. This option is only supported on Itanium platforms.
+[no]strip
+strip causes the linker to strip symbol table information from the executable
program. This option is incompatible with the -g option. The default is +nostrip.
The -s option can be used to perform the same function as +strip.
-tx,path
-t looks in path for the subprocess identified by x and substitutes it for the default
subprocess. x can be one or more identifiers indicating the subprocesses.
This option works in two modes:
•If x is a single identifier and path ends in with a slash (/), path represents the
directory with the new subprocess, and the name of the subprocess is the standard
name. If path ends in a filename, it is the name of the subprocess.
•If x is a set of identifiers, path is a directory that holds the subprocesses identified
in x. The subprocesses in path have their standard names.
Table 2-7 lists the identifiers for x, the subprocesses each indicates, and the
standard subprocess name.
The following example of the -t option tells the compiler to pass the source files to
the K&R version of the C preprocessor for preprocessing:
-tp,/usr/ccs/lbin/cpp
Table 2-7 Values for the -t option x subprocesses
Value Subprocess Standard name
a Assembler as
c Compiler f90com
e Debug file end.o
l Linker ld
p C preprocessor cpp