HP-UX 11i v3 Installation and Update Guide, March 2012

Figure 6 Software Selection Tab
Use the spacebar to select or deselect software from the list.
NOTE: You might observe a few seconds of delay each time you select or deselect a software
item on this screen.
Select any optional software that you want and deselect any recommended (default-installed)
software that you do not want. Browse the list, marking your selections.
The bundles and associated product names are listed in Appendix C: “HP-UX 11i v3 Operating
Environment software bundles” (page 84). For information about new and changed products and
features, see the HP-UX 11i Version 3 Release Notes appropriate for the release to which you are
updating. The document is available on the Instant Information DVD and at http://www.hp.com/
go/hpux-core-docs-11iv3.
CAUTION:
HP recommends that you do not deselect recommended software bundles or remove them from
your system unless you know for certain that the software contained in these bundles is not required
for your OE.
If you deselect recommended software during the update, the old version of the software you
deselected will remain on your system. The old version might not be compatible with the newly
updated HP-UX 11i v3 OE. In addition, software might have unstated dependencies. Deselecting
software might prevent some products from functioning correctly because they have dependencies
on the software you deselected.
The flag M (Match) appears when software has been matched to software currently installed on
your system. The flag P (Partial) might appear if you select only a component of a software object
or if such components are automatically selected due to dependencies.
The software products in each category have an associated flag that is displayed in the left-hand
column and are described below:
• S is selected by the user.
• ! is deselected by the user.
• D is a dependency.
• A is automatically selected.
• P is partially selected.
Proceeding with updating 53