HP-UX 11i v3 Installation and Update Guide, September 2009 (Update 5 Release)

Table A-2 Known install and update problems (continued)
Description/actionProblem
While updating from a previous OEUR to the HP-UX 11i v3 September
2008 OEUR and beyond, the following message may be logged onto the
console:
/sbin/rc[14]: /sbin/rc2.d/S700vxatd: not found.
What to do
This is a harmless message. Installation is not affected. Veritas
Authentication Service (VRTSat) will start without any problem once
the update is complete.
Update from previous OEUR
to HP-UX 11i v3 September
2008 and beyond may log
harmless message on console
regarding VRTSat
While cold-installing HP WBEM Services, the SSL certificates are
generated with short host names. These certificates cannot be used by
the WBEM Service clients. The following warning message is logged in
the swagent.log file:
Note: Cannot find the fully-qualified domain name
(FQDN) for this system, SSL certificates for WBEM
Services are created with the short hostname. Correct
this either by editing the /etc/hosts file or by
making the appropriate DNS registration. If not
corrected, the created certificates may not be
acceptable to the WBEMService clients that expect a
FQDN in the common name field of the SSL certificate.
After the hostname(FQDN) is configured, run /opt/wbem/
sbin/gen_wbem_certs to create SSL certificates for
WBEMServices. The existing certificates /etc/opt/hp/
sslshare/cert.pem and /etc/opt/hp/sslshare/file.pem
will be moved to /etc/opt/hp/sslshare/cert.pem.bak
and /etc/opt/hp/sslshare/file.pem.bak respectively.
What to do
As a workaround, after configuring the host name, run the
/opt/wbem/sbin/gen_wbem_certs utility to create SSL certificates
for HP WBEM Services.
SSL certificates generated
while cold-installing HP
WBEM Services A.02.09 may
not be accepted by WBEM
Service clients
104 Known install and update problems