HP-UX 11i v3 Installation and Update Guide, September 2009 (Update 5 Release)

Table A-2 Known install and update problems (continued)
Description/actionProblem
When OnLineJFS 5.0 (B3929FB) is selected during an update from 11i
v2 OnlineJFS 4.1 to 11i v3 with OnlineJFS 5.0 (B3929FB), the following
selection time warning from update-ux may be seen:
WARNING: The following was found while selecting
software:
- There are new revisions of SW available in the
source that would update SW already installed on the
system. The newer revisions are not selected for
installation. This could leave the incompatible old
revision of SW on the system. The affected SW is:
- OnlineJFS.VXFS41-AD-RN,r=B.11.31 replaces
OnlineJFS01.VXFS41-AD-RN,r=4.1.004
What to do
This warning can be safely ignored. The update will complete successfully
despite this warning. For complete installation instructions, see also
Appendix B: “Installing VxFS and VxVM” (page 115).
Warning message during
update from HP-UX 11i v2
with OnlineJFS 4.1 to HP-UX
11i v3 with OnlineJFS 5.0
Updating from the HP-UX 11i v2 release to the HP-UX 11i v3 release
may cause the following error to appear in the swagent.log:
cp: cannot access /.secure/etc/*: No such file or
directory
What to do
You can safely ignore this message.
Cannot Access /.secure/
etc/* error message
Configuring a vPar with a low amount of base memory can result in
system hang or lead to slow system performance.
What to do
Configure vPars with enough base memory as per the below guidelines:
• If there is 1 GB to 8 GB total memory assigned to the Virtual Partition:
make sure the minimum base memory is 1/2 of total memory.
• If there is 8 GB to 16 GB total memory assigned to the Virtual Partition:
make sure the minimum base memory is 4 GB.
• If there is over 16 GB total memory assigned to the Virtual Partition:
make sure the minimum base memory is 1/4 of the total memory.
Configuring vPar with low
base memory results in
system hang or slow
performance
109