HP-UX 11i v3 Installation and Update Guide, September 2009 (Update 5 Release)

NOTE: The following figure shows consoles with a primary (P) status and
secondary (S) status. This would not be correct for your configuration. You
should select only one device for a P status. The rest should be given an NC
status.
Only one active console should be configured; otherwise, HP-UX may either
fail to boot or boot with output directed to the wrong location.
e. Press Esc to return to the boot option maintenance menu.
f. Select Cold Reset to reset your system.
Mounting and unmounting the DVD
Mounting the DVD
For some tasks, you may need to mount the DVD as a file system. To do so, take the
following steps:
1. Insert the DVD into the DVD drive.
2. Find the DVD-ROM device file name:
ioscan -C disk -f -n -k | more
A typical device name is /dev/dsk/c1t2d0
3. Create a directory under root (/). For example:
mkdir /dvdrom
4. Mount the DVD onto the new directory as a file system. For example:
mount /dev/dsk/c1t2d0 /dvdrom
34 Before you begin