HP-UX 11i v3 Installation and Update Guide, September 2009 (Update 5 Release)

Table 5-1 Miscellaneous data
Your specific dataType of data
Root Disk Path
NOTE: Your root disk will typically display a legacy style
Path name. However, HP-UX 11i v3 contains a new naming
scheme for Root Disks. Refer to the white paper “The Next
Generation Mass Storage Stack: HP-UX 11i v3” for
information on how to identify your legacy root disk device
name in the agile HP-UX 11i v3 naming scheme. You can
display the legacy hardware path using the More Info screen
to show details on a specific lunpath hardware path.
Root Swap Space
File System Type
LVM with VxFS (4.1 or 5.0), VxVM 5.0 with VxFS 5.0, or
Whole disk with VxFS (4.1 or 5.0)
Root Disk Volume Group Disks
(How many disks you want placed into the root disk volume
group, and whether or not you want the disks to be striped
or mirrored.)
Physical Location for SAS
(Physical Location is the enclosure and bay. WWID can also
be used if known.)
WWID for Fibre Channel (FC)
(The storage administrator should provide WWID details
for storage presented to the system. Knowing the WWPN
of the adapters may also be useful.)
WWID for Fibre Channel (FC) Virtual Connect (VC)
(WWID may have been presented to the WWPN in the VC
profile that to be used with the Blade. The profile must be
assigned to the Blade prior to HP-UX install.)
Select additional software
Pre-Installed Disk Information (Is overwritten during the
install disk; see Root Disk Path)
Network data collection table
In addition to areas to record network data, Table 5-2 provides HP-UX commands that
you can use after the installation to confirm the information.
Preparing to cold-install 45