HP-UX 11i v3 Installation and Update Guide, September 2009 (Update 5 Release)

2. In the Environments field, select the type of Operating Environment you want to
install on your system. Press Enter to view the choices.
3. In the Root Disk field, select the disk to store your root file system. Press Enter
to view the choices. If you are unsure of what to choose, keep the default selection
that has been determined by Ignite-UX.
HP-UX 11i v3 contains a new naming scheme for Root Disks. Note that the Root
Disk screen displays the lunpath hardware path instead of the legacy hardware
path. You can select More Info to view the legacy hardware path for the root disk
selected.
For further information, including disk requirements, supported peripherals, and
preparing the client for installation, see the Ignite-UX Administration Guide (http://
docs.hp.com/en/oshpux11iv3.html#Ignite-UX).
NOTE: The lunpath hardware path selected is used only to identify the Root
Disk itself, and any available path to that disk may then be used as boot path.
Therefore, it is normal to see a different lunpath hardware path to the disk used
as boot path.
4. In the File System field, select the type of volume manager and file system you
want to use for your root disk. Press Enter to view the choices.
5. In the Languages field, press Enter to browse the available languages, marking
the desired selections. You can make any of the selections your system default
language. This will become the system default language after it is installed. Make
sure HPUXLocales is marked Yes.
The locale settings that were previously in HP-UX 11i v2 and located in the
Common Desktop Environment (CDE) language bundle are now located in the
HPUXLocales bundle. The HPUXLocales bundle contains internationalization
support for many languages. This support includes date and time formats, currency,
sorting methods, and so on.
NOTE:
CDE is an optional product in HP-UX 11i v3. If you require it, you must explicitly
select the CDE bundle (CDE-xxx). This applies if you need dtterm, which is
located in CDE. For some localization situations, dtterm is required; therefore
CDE must be selected.
6. Use the Software tab to change the software that will be installed on your system,
if desired. If you choose the No User Interface option, then you cannot deselect
the recommended (default-installed) software bundles.
To select or deselect the software bundles:
Proceeding with the installation 51