HP-UX 11i v3 Installation and Update Guide, September 2009 (Update 5 Release)

The File System tab will differ in appearance, depending on whether you
previously selected LVM or whole disk on the Basic tab.
Note that renaming or changing any disk file system structure on which Ignite-UX
installs file system content causes the old file system on that disk to be lost. For
more information on using the File System tab, refer to the Ignite-UX Administration
Guide (http://docs.hp.com/en/oshpux11iv3.html#Ignite-UX).
9. Use the Show Summar y button to view a summary of how your system will be
configured. If you see any problems, or want to change any of your selections,
back up to the appropriate step, and make the needed changes. Otherwise, select
Go! (at the bottom of the screen) to initiate the installation.
Ignite-UX executes a pre-installation consistency check to identify any errors that
must be corrected before the installation can proceed.
10. The system typically displays the Confirmation Dialog box that lists errors,
warnings, and notes for the configuration settings. (For information on these
messages, see “Messages: errors, warnings, and notes” (page 36).) Review any
errors, warnings, or notes displayed in the Confirmation Dialog box. If there are
any errors, they will need to be resolved before the installation can continue.
Warning messages will list which disks (ones that currently contain a recognized
file system) will be overwritten during the install process. If you see a disk in the
list that you do not want included, back up to the root disk selection and choose
another disk. If the settings are correct, continue on to the next step.
11. After you have reviewed all of the information on the Confirmation Dialog box
and resolved any errors, select Go! (at the bottom of the screen) to initiate the
installation.
As the installation proceeds, you will see a log detailing output from the software
installation. After the software is installed, the system will reboot prior to
configuring the software and once again after installation is complete.
If your system was factory integrated, or if you chose to set the system parameters
at the first boot of your system, the system will power down after the installation
and ask for these system parameters at the next boot of your system.
Finishing your installation
Reboot your system. The Welcome to HP-UX screen is displayed and you will be
prompted through a series of screens.
You may need to select or specify other available networking drivers to enable other
cards on your system.
1. To use a keyboard on this interface, you must specify a language mapping to be
used by X Windows and the Internal Terminal Emulator (ITE). Choose the
appropriate language. For English, select number 26.
Proceeding with the installation 53