HP-UX 11i v3 Installation and Update Guide, September 2009 (Update 5 Release)

Figure 6-3 Select Source Tab
a. Specify the source depot that contains the new OE that you want to use to update
your target system. The system automatically selects the local host and default
depot path.
You can expand any entry that is preceded by the + sign. This allows you to view
the available depots on the server.
b. If the depot containing the software you want to install does not appear in the list,
you can do one of the following:
• Add another host system to the list of registered source depots by entering s
(Add Server/Depot) and then entering the name of the new source host;
or
• You can also remove a host system from the list of registered source depots
by entering d (Delete Server).
c. Press Enter. The system retrieves all the depots available for the host name specified
and displays a list of registered depots on the source host.
d. Use the spacebar to select the depot containing the software you want to install.
e. Enter n (next) to confirm your selection and proceed to the OE-Selection tab. (The
system displays the message Reading Data from Source before displaying
the next tab.)
Step 3: Select OE
The OE-Selection tab appears.
Proceeding with updating 65