HP-UX 11i v3 Installation and Update Guide, September 2009 (Update 5 Release)

Figure 6-6 Analysis Dialog
b. The preview stops after the analysis. Press Enter to return to the SW-Selection
tab.
c. After returning to the SW-Selection tab, enter l (log) to view the log file, which
presents a view of detailed install information.
d. Review any errors, warnings, or notes. Warnings and notes are simply
informational. If there are any errors, they will need to be resolved before the
update can continue.
Step 6: Update
In this step, the system proceeds with the actual update. At the SW-Selection tab,
enter i (install) to start the update process. After the update has started, the system
will typically execute a reboot.
After your system has completed its reboot, you will be prompted to change DVDs if
and when needed.
Step 7: Verify update
Use the following steps to verify that the update completed successfully:
a. Verify that no errors were encountered before the update began by viewing the
contents of the log file: /var/adm/sw/update-ux.log. You should see output
similar to the following:
Command entered: update-ux -s
depot_server:/var/11iv3/update_depot SWM HPUX11i-OE
NOTE: Output is logged to '/var/adm/sw/update-ux.log'
* Obtaining some information from the source depot.
cp /usr/lbin/swagent /var/adm/sw/tmp/update-ux
Proceeding with updating 69