HP-UX HB v13.00 Ch-04 - System Recovery

HP-UX Handbook – Rev 13.00 Page 25 (of 54)
Chapter 04 System Recovery
October 29, 2013
[ 0/4/0/0/7/0 lan2 0x0010837B2A11 HP_A5838A_PCI_100Base-TX/SCSI_ ]
[ 0/7/0/0 lan3 0x001083FC0354 HP_A4926A_PCI_1000Base-SX_Adap ]
Select the desired interface card, and press return. The system continues displaying the
following messages:
* Searching the network for a DHCP server to supply default networking
information....
This could take up to 30 seconds if a DHCP server cannot be found. If
you wish to cancel the DHCP server search, you may press CTRL-C now.
Press Ctrl-C unless you want to fetch the network configuration from a DHCP server.
After interruption this message is displayed:
* Could not get DHCP information. No host specific network defaults
will be supplied. (dhcpclient returned: 9)
NETWORK CONFIGURATION
This system's hostname:
Internet protocol address (eg. 15.2.56.1) of this host:
Default gateway routing internet protocol address:
The subnet mask (eg. 255.255.248.0 or 0xfffff800):
IP address of the Ignite-UX server system: 15.140.11.156
Is this networking information only temporary? [ No ]
[ OK ] [ Cancel ] [ Help ]
Enter the configuration parameters and confirm them by selecting OK. The system
continues, displaying the following or similar messages:
* Bringing up Network (lan0)
add net default: gateway 15.140.8.65
* Reading configuration information from server...
* Loading insf to create disk device files...
* Creating disk device files...
* Loading the recovery commands...
(c) Copyright 1983, 1984, 1985, 1986 Hewlett-Packard Co.
(c) Copyright 1979 The Regents of the University of Colorado, a body corporate
(c) Copyright 1979, 1980, 1983 The Regents of the University of California
(c) Copyright 1980, 1984 AT&T Technologies. All Rights Reserved.
HP-UX NETWORK SYSTEM RECOVERY
WARNING: YOU ARE SUPERUSER !!
Checking for required components on the Ignite Server........
loading commands into memory....