HP-UX HB v13.00 Ch-04 - System Recovery

HP-UX Handbook – Rev 13.00 Page 50 (of 54)
Chapter 04 System Recovery
October 29, 2013
sync'ing disks (0 buffers to flush):
0 buffers not flushed
0 buffers still dirty
System has halted
OK to turn off power or reset system
Restoring the volboot file
Boot the system to VxVM maintenance mode.
fs1:\> hpux -vm
VxVM maintenance mode
*** HP-UX Boot Loader for IA-64 ****
*** Version 1.639 ****
*** Type 'help' for help ****
Press Any Key to interrupt Autoboot
\efi\hpux\AUTO ==> boot vmunix
Seconds left till autoboot - 10
HPUX> boot vmunix -vm
> System Memory = 4091 MB
loading section 0
................................
loading section 1
....
Loading symbol table. Num of Sec Header(29)
Loading System Directory(boot.sys) to MFS
......
Loading Kernel Boot Directory(boot.3AB7B59C4184) to MFS.
.....
Launching /stand/vmunix
SIZE: Text:16182K + Data:1558K + BSS:1409K = Total:19151K
Booting kernel...
Console is on Serial COM1
PAL_DEBUG_FEATURE [CPU 0]: 0x4, multi-dispersal
PAL_DEBUG_FEATURE [CPU 1]: 0x4, multi-dispersal
PAL_DEBUG_FEATURE [CPU 2]: 0x4, multi-dispersal
PAL_DEBUG_FEATURE [CPU 3]: 0x4, multi-dispersal
NOTICE: nfs3_link(): File system was registered at index 4.
NOTICE: cachefs_link(): File system was registered at index 5.
NOTICE: autofs_link(): File system was registered at index 6.
qlisp_multi(0): QLogic 12160 dual Ultra3 SCSI
qlisp(3): Loaded QLogic ISP, Ver: 10.04.08, Mode: NV-AUTO DMA64 FP
Boot device's HP-UX HW path is: 0.18.1.2.0.0.1.0
System Console is on the Built-In Serial Interface
Swap device table: (start & size given in 512-byte blocks)
entry 0 - auto-configured on root device; ignored - no room
WARNING: no swap device configured, so dump cannot be defaulted to primary swap.
WARNING: No dump devices are configured. Dump is disabled.
Starting the STREAMS daemons-phase 1
Starting vxconfigd in boot mode (pre_init_rc).
INFO: VxVM Maintenance Mode Boot - vxconfigd aborted
Checking root file system.
file system is clean - log replay is not required
Root check done.
Create STCP device files
Starting the STREAMS daemons-phase2
$Revision: vmunix: vw: njl selectors: CUPI80_BL2001_0223 xxx_xxx 'CU$
Memory Information:
physical page size = 4096 bytes, logical page size = 4096 bytes
Physical: 4190020 Kbytes, lockable: 2966672 Kbytes, available: 3122952 Kbytes