HP Instant Capacity Version 10.x User Guide (5900-1581, March 2011)

exception reports for the local system. This field is set via
the icapmodify -c command.
From email: This field displays the email address that will be specified
as the sender of all Instant Capacity initiated email
correspondence for the local system. This field is set via the
icapmodify -f command. If not set, email will be sent
from the adm user on the local system.
Asset reporting: This field indicates if the Instant Capacity software on the
local system is presently configured to send email asset
reports to HP. This is configured using the icapnotify
-a command.
Temporary capacity warning period: This field displays the number of days constituting the
temporary capacity warning period for the complex. When
the temporary capacity balance is projected to be depleted
within this number of days, a warning message is sent by
email to the system contact and to root. The value of the
warning period can be set using the icapmodify -w
command.
Exception Status: This field indicates if the complex is presently in an exception
state. A complex is usually in an exception state when the
number of active components of a given type (cores, cells,
memory) exceeds the number of available usage rights for
that component type. The one exception is that the number
of active cores is allowed to exceed the number of core
usage rights as long as there is a sufficient positive balance
of temporary capacity. A negative temporary capacity
balance is always an exception state.
Information displayed for a GiCAP group
The following status information is displayed when the system is a member of a GiCAP group.
Member <mname> in GiCAP group
<gname>
This section heading identifies the member name (<mname>)
and the name of the GiCAP group (<gname>) that includes
this system as a member.
Active Group Manager: This field identifies the name of the active Group Manager
system where you can get more detailed information about
the group, by invoking the icapmanage command (see
icapmanage(1M)).
Standby Group Manager: This field identifies the name of the standby Group Manager
system, if a standby has been defined for the group. The
standby Group Manager has the ability to take control of
the group if the active Group Manager should become
unavailable for any reason. The field is displayed as “N/A”
if no standby Group Manager has been defined for the
group.
Borrowed/Loaned core usage rights: This field identifies the count of core usage rights that were
either borrowed from or loaned to the GiCAP group. This
value must be 0 in order to remove the member from the
GiCAP group.
Borrowed/Loaned cell usage rights: This field identifies the count of cell board usage rights that
were either borrowed from or loaned to the GiCAP group.
This value must be 0 in order to remove the member from
the GiCAP group.
149