HP Instant Capacity Version 10.x User Guide (762794-001, March 2014)

Table 10 TiCAP Preauthorization usage matrix (continued)
Partition state after
operation completed
Example: Partition
state before
operationComments
When to use
it?Operation
TiCAP
Preauthorisation
flag -T (on/off)
Partition
Type
Total core usage
rights=4
Total core usage
rights=4
nPAR will
boot up
If sufficient
RTUs are not
RebootONnPAR
Committed core
usage rights =4
Committed core
usage rights =4
using
RTUs only
or using
available to
boot nPAR with
IA cores and
Available core usage
rights=0
Available core
usage rights=0
both
TiCAP
user want to
reboot nPAR
balance
and RTUs.
using TiCAP
balance.
Total TiCAP
balance=10 hours
Total TiCAP
balance=10 hours
Total cores=8Total cores=8
Actual Active=8Actual Active=6
Intended Active=8Intended Active=8
Cores using TiCAP=4Cores using
TiCAP=2
Total core usage
rights=4
Total core usage
rights=4
nPAR will
reboot
If sufficient
RTUs are
RebootOFFnPAR
Committed core
usage rights =4
Committed core
usage rights =4
using
RTUs. But
before
available to
boot nPAR with
IA cores.
Available core usage
rights=0
Available core
usage rights=0
reboot if
npar was
using
Total TiCAP
balance=10 hours
Total TiCAP
balance=10 hours
TiCAP,
then it
Total cores=8Total cores=8
continue
Actual Active=6Actual Active=6
to use
same
Intended Active=8Intended Active=8
TiCAP
Cores using TiCAP=2Cores using
TiCAP=2
even after
reboot.
Total core usage
rights=6
Total core usage
rights=6
vPAR will
boot with
If sufficient
RTUs for the
Power-on/bootONvPAR
Committed core
usage rights =6
Committed core
usage rights =6
all
assigned
cores to it
cores assigned
to a vpar are
not available
Available core usage
rights=0
Available core
usage rights=0
or not at
all. That
and user want
to use TiCAP to
boot a vpar.
Total TiCAP
balance=10 hours
Total TiCAP
balance=10 hours
is, if
sufficient
RTUs and
Total cores=8Total cores=8
TiCAP
Actual Active=8Actual Active=8
balance is
not
Cores using TiCAP=2Cores using
TiCAP=2
available
to boot all
the
assigned
cores in a
vpar, it
will not
boot up.
vPAR will not boot up
until sufficient RTUs
Total core usage
rights=6
vPAR will
boot with
If sufficient RTU
for the core
Power-on/bootOFFvPAR
are present for all 8
Committed core
usage rights =6
all
assigned
cores to it
assigned to a
vPAR are
available or
cores or –T flag is on
to use TiCAP balance
to boot up.
Available core
usage rights=0
or not at
HP Integrity Superdome 2 with dynamic cores 105