HP Instant Capacity Version 10.x User Guide (762794-001, March 2014)

9 Troubleshooting
This chapter covers the following topics:
• “Handling compliance exceptions” (page 117)
• “Troubleshooting the iCAP software” (page 120)
• “Diagnosing email configuration” (page 122)
• “Resolving errors during addition of standby GM” (page 122)
• “Handling errors while re-adding GiCAP member” (page 122)
• “Negative cores without usage rights value in icapmanage -s output” (page 123)
• “Behavior on occurrence of INIT (TOC) in nPartition” (page 123)
Handling compliance exceptions
A complex can get out of compliance with the iCAP contract if any of the following occurs:
• More cells are active than expected (not enough inactive cells).
• More memory is active than expected (not enough inactive memory).
• More cores are active than expected (not enough inactive cores).
• There is a negative temporary capacity balance.
• (GiCAP) Sharing rights are insufficient.
• (GiCAP) Hardware is added that is incompatible with the group.
NOTE: Your system might be out of compliance because it has different iCAP software products
installed. For example, if a partition has the old product B9073AA installed (iCAP versions B.03.x
through B.05.x) and another partition in the same system has the new product B9073BA installed
(iCAP version B.06.00 or greater), the B9073BA software determines that all components in
partitions that have B9073AA installed are active. For details of correcting this noncompliant state,
see “Upgrading to Instant Capacity version B.06.x or later (HP-UX)” (page 202).
The iCAP software sends an exception report (via email) if one of these exception conditions occurs.
Exception information is also written to the system log file. In some cases, compliance is enforced
by deactivating cores at boot time. For more details about enforcement, see “TiCAP expiration
and compliance enforcement” (page 58) and virtual partition “Boot time compliance” (page 46).
Example 28 shows an email exception report for having more cores active than expected.
Handling compliance exceptions 117