HP Instant Capacity Version 10.x User Guide (762794-001, March 2014)

2. Look for the certificate which contains the Common Name mentioned in the OA certificate on
the member. OA certificate information can be obtained on the member, by executing Show
OA certificate on the OA cli.
3. Then execute the cimtrust -r i <Issuer> -S <Subject> command to remove the
certificate. Issuer and subject information should be taken from cimtrust -l output.
Negative cores without usage rights value in icapmanage -s output
If icapmanage -s reports a negative cores without usage rights value after a seize operation is
performed on one of the members, you must execute icapmanage -s on the GM again after
sometime and the correct data will be displayed in the output.
Behavior on occurrence of INIT (TOC) in nPartition
Once INIT (TOC) occurs on HP-UX in an nPar, the number of the cores activated in the nPar
reduces to one. After the subsequent partition reboot, the nPar tries to use the same number of
cores that are set to the IA value from the FWBOOT run status. You might need to adjust the IA value
for each nPar.
NOTE: This behavior is available in the complex firmware bundle 3.6.48 or later.
Negative cores without usage rights value in icapmanage -s output 123