HP Instant Capacity Version 10.x User Guide (762794-001, March 2014)

Error: Deferred activation/deactivation are not allowed on vPars.
#
Action: Deferred activations and deactivations with icapmodify are not supported in any virtual
partition environment.
(2.53.0 FW or earlier)
# vparmodify -p 2:1 -a socket:1/4/0:core::4
Error: vparmodify command failed.
Error: Insufficient CPU cores in a socket during add or delete in a
virtual partition.
#
(3.6.48 FW or later)
# vparmodify -p 2:1 -a socket:1/8/0:core::4
Error: vparmodify command failed.
Error: Requested CPU core(s) are unavailable in the socket for an add/delete operation in
the vPartition.
#
Action: Check the available resources in the socket.
OA> vparmodify -p 2:2 -m core::8
Error: vparmodify command failed.
Error: The minimum limit is more than the total number of CPUs reserved for a
virtual partition.
OA> vparmodify -p 2:2 -m core::25
Error: vparmodify command failed.
Error: The maximum limit is less than the total number of CPUs reserved for a
virtual partition.
OA> icapmodify -p 2:2 -s 8
Deactivate operation encountered problems..
Error: The minimum limit is more than the total number of CPUs reserved for a
virtual partition.
(2.53.0 FW or earlier)
OA> icapmodify -p 2:2 -s 25
Error: The maximum limit is less than the total number of CPUs reserved for a
virtual partition.
(3.6.48 FW or later)
OA> icapmodify -p 2:2 -s 25
Error: Authorization requested for more than available cores for this Vpar:0
24 cores have been already activated in the virtual partition where the minimum and maximum
number of CPUs are configured as "16/24". The count of CPUs in the virtual partition must always
be within the configured range.
Action: Adjust the number of cores within the configured CPU range.
GiCAP
# icapmanage -C \
nLktFRA.CNrWLb7.K91qJrB.jB7EdhJ.2-ubqMkUb.MNP3xzR.gUudT49.wgiehP
ERROR: This codeword cannot be applied. The Virtual Partition ID is incorrect.
Please verify that this is the correct system.
icapmanage command failed.
#
Applying a GM codeword created for nPar 1 does not work for any vPar.
Action: Apply the codeword on the requested nPar.
# icapmanage –a –m sd2prod1:sd2prod1oa1.corp.hp.com -g CloudProd
Enter the password for the administrator on sd2prod1oa1.corp.hp.com:
Enter the password for active_gm on sd2prod1oa1.corp.hp.com:
icapmanage command failed.
126 Troubleshooting error messages