HP Instant Capacity Version 10.x User Guide (762794-001, March 2014)

Use icapmanage -Q to set this Group Manager as the active Group Manager for all
GiCAP group members. Split GiCAP group occurs.
#
Action: Choose AGM from either of the configured GMs and execute icapmanage -Q there.
# icapmanage –a –m sd2prod2:sd2prod2oa1.corp.hp.com -g CloudProd
Enter the password for the administrator on sd2prod2oa1.corp.hp.com:
Enter the password for active_gm on sd2prod2oa1.corp.hp.com:
NOTE: Could not set up secure communication between the standby Group Manager
(sgm.corp.hp.com) and one or more of the member hosts. If sgm.corp.hp.com
becomes the active manager, it may not be able to take control of this group member.
This can happen for a number of reasons. Fix any problems noted below,
then reissue this command.
NOTE: CIM_ERR_NOT_FOUND: PGS03318: The certificate does not exist.
Member sd2prod2 added to group CloudProd.
#
nl
The member is added to the group, but the member OA certificate had been present in the trust
store on SGM.
Action: Remove the added member from the group. Remove the OA certificate from the trust store
both on AGM and SGM with the cimtrust command (see the topic Handling errors while
re-adding GiCAP member in chapter 9). Add the member back.
# icapmanage -s
..(snip)..
64 GiCAP Sharing Rights for SD2: 40 in use, 24 available
..(snip)..
# icapmanage -a -m sd2prod3:sd2prod3oa1.corp.hp.com -g CloudProd
Enter the password for the administrator on sd2prod3oa1.corp.hp.com:
Enter the password for active_gm on sd2prod3oa1.corp.hp.com:
icapmanage command failed.
sd2prod3 has 48 cores without usage rights but the GiCAP management software
has 24 GiCAP sharing rights available.
#
The member OA still remembers the out-of-date iCAP inventory after removing 3 i2 iCAP blades
due to any reason.
Action: Restart the active OA to let it recognize the latest iCAP inventory.
# icapmanage –s
..(snip)..
sd2prod2 (cannot be contacted)
sd2prod2oa1.corp.hp.com, sd2prod2oa2.corp.hp.com
..(snip)..
# icapmanage -r -m sd2prod2
icapmanage command failed.
Cannot contact any known OS host on GiCAP member sd2prod2.
#
AGM cannot communicate with either of the OAs for the member.
Action: Fix the communication issue.
# icapmanage –s
..(snip)..
Group Members:
sd2prod1 (cannot be contacted)
sd2prod1oa1.corp.hp.com
..(snip)..
# icapmanage -r –m sd2prod1
icapmanage command failed.
Cannot contact any known OS host on GiCAP member sd2prod1.
#
132 Troubleshooting error messages