HP Instant Capacity Version 10.x User Guide (762794-001, March 2014)

3 Installing and removing iCAP software
This chapter covers the following topics:
• “Installing iCAP software” (page 32)
• “Reinstalling iCAP software” (page 34)
• “Removing iCAP software” (page 34)
Installing iCAP software
Factory Integrated Systems
The iCAP software is installed by HP on all HP enterprise servers, even those without iCAP
components. To verify that the software is installed and configured, use the following HP-UX
command :
/usr/sbin/swverify iCOD
The command output displays the message Verification succeeded .
IMPORTANT: The iCAP software is automatically installed when the HP-UX 11i v1, 11i v2, or
11i v3 Operating Environment (OE and Application) is installed. If any partition in the system has
version B.06.x or later installed, then all partitions in the system with iCAP software must be running
version B.06.x or later. For details about upgrading the software from a version previous to B.06.x,
see “Upgrading to Instant Capacity version B.06.x or later (HP-UX)” (page 202).
For HP-UX you generally do not need to install the iCAP software. However, if you do, it is available
from the following media/location:
• HP software depot at http://www.hp.com/go/softwaredepot
• HP-UX 11i v3 Operating Environments (OE) and Application media.
If the system is a Group Manager or a member of a GiCAP group, prior to installing the iCAP
version 9.0 software, ensure that WBEM version A.02.09 or later is installed, set the CIM Server
configuration property sslClientVerificationMode to “optional”, enableHttpsConnection to “true”,
and restart the cimserver on the Group Manager, the standby Group Manager (if any), and on
all HP-UX OS instances of all member systems. Because this configuration attribute is not dynamic,
you must specify the -p option, and you must restart the cimserver to set the value. For details, see
cimconfig(1M).
Use the following commands to set sslClientVerificationMode and enableHttpsConnection properly.
Afterwards, restart the cimserver:
# cimconfig -s sslClientVerificationMode=optional -p
# cimconfig -s enableHttpsConnection=true -p
# cimserver -s; cimserver
Use the following command to verify the value of sslClientVerificationMode after a restart:
# cimconfig -g sslClientVerificationMode -c -p
PGC00213: The current property value is optional.
PGC00212: The planned property value is optional.
# cimconfig -g enableHttpsConnection -c -p
PGC00213: The current property value is true.
PGC00212: The planned property value is true.
Installing from the HP-UX media (HP-UX 11i v1, 11i v2, and 11i v3):
Follow this procedure to install the iCAP software on your HP-UX system from either the appropriate
HP-UX Applications Software or OE media:
1. Log in as root.
32 Installing and removing iCAP software