HP Instant Capacity Version 10.x User Guide (762794-001, March 2014)

2. Determine the DVD drive device file by entering the following command:
ioscan -fnC disk
3. Insert the appropriate HP-UX Applications Software or OE DVD into the DVD drive.
4. Mount the DVD drive to the desired directory. The following example uses the /dev/dsk/
c1t2d0 device file (from step 2) and the /dvd directory. To mount the DVD drive, enter a
similar command as:
mount -r /dev/dsk/c1t2d0 /dvd
5. Install the B.10.x bundle B9073BA from the DVD:
swinstall -s /dvd B9073BA
6. Continue with “For all HP-UX installations” (page 33).
Installing from the HP software depot (For HP-UX 11i v1, 11i v2, and 11i v3):
1. Search for B9073BA on the HP software depot website:
http://www.hp.com/go/softwaredepot
2. Select the link that appeared as a result of your search, and follow the instructions on the
Installation page.
3. Continue with “For all HP-UX installations” (page 33).
For all HP-UX installations
After you have successfully installed the iCAP software using the swinstall command, perform
the following procedure to validate your installation:
1. Execute the /usr/sbin/icapstatus command.
2. Verify that the icapstatus command output indicates the correct number of components
without usage rights for cells, cores, and memory.
If any number is incorrect, contact your local HP Response Center and request iCAP assistance.
3. Log in as root
4. Set the system contact information by entering the following command:
/usr/sbin/icapmodify -c <contact_email_address>
5. If you want to configure asset reporting, then ensure that outgoing mail can be sent to HP mail
servers from your system, even if the system is behind a firewall. See “Diagnosing email
configuration” (page 122).
• Test the transmission of your asset report, via email to HP, by entering the following
command:
/usr/sbin/icapnotify <reply_address>
The icapnotify command sends an asset report to HP, root, and the supplied reply
address.
HP responds with an email to the reply address after the asset report is received.
• Use an email client to verify the return email from HP to the reply email address.
Installing iCAP on OpenVMS systems
On OpenVMS systems, the iCAP software is automatically installed on partitionable systems when
the OpenVMS Version 8.3 or later operating system in installed. You should not need to install the
iCAP software separately on OpenVMS systems. iCAP hardware components have already been
configured at the factory before delivery. The iCAP software is included on the OpenVMS Version
8.3 Operating Systems media.
To verify that the iCAP software is installed and configured, run the following OpenVMS commands:
Installing iCAP software 33