Instant Capacity on Demand (iCOD) User's Guide for versions B.05.x

Installing and Uninstalling iCOD Software
Uninstalling iCOD Software
Chapter 3 49
Uninstalling iCOD Software
If you have fulfilled all of the iCOD program requirements, see “When
iCOD Program Requirements End” on page 40, the system is no longer
considered an iCOD system. Therefore, the iCOD software is no longer
necessary and can be removed.
On iCOD
Hardware-
Partitionable
Systems:
When running the iCOD software on hardware-partitionable systems,
the number of iCOD processors is audited for your complex as a whole,
not an individual partition. You may find it necessary to redistribute
active processors from one partition to another, and at times remove the
iCOD software from a partition. It is important not to remove the iCOD
software from all partitions in your complex unless you have activated
and purchased all iCOD processors.
On All Systems: Remove the iCOD software bundle:
/usr/sbin/swremove B9073AA
For hardware-partitionable systems, you need to run this command on
each iCOD partition in the complex.
NOTE This command fails if any of the following conditions are true:
• all processors are not activated
• the requested number of active processors does not equal the total
number of processors