HP-UX vPars and Integrity VM V6.3 Administrator Guide

# olrad -r 10-0-1-0-2-3
Activity : Start of Prepare Replace
Target slot : 10-0-1-0-2-3
Critical Resource Analysis(CRA) in progress...
[NOTE: The CRA may take a few minutes to complete on large
configurations. It is recommended not to disrupt this operation.]
CRA REPORT SUMMARY: CRA returned WARNING.
Detailed CRA report is available in /var/adm/cra.log file.
CRA output : resources in use on affected device(s)
Target slot : 10-0-1-0-2-3
Activity : End of Prepare Replace
Target slot : 10-0-1-0-2-3
Activity : Target slot powered off, drivers suspended, OK to replace the card
Target slot : 10-0-1-0-2-3
To verify that the DLA NIC is successfully suspended on host and guest, options of the olrad(1M)
and ioscan(1M) commands can be used as in previous examples.
Further, nwmgr output inside the guest will also show that the active port of APA has changed.
In this example, nwmgr output shows lan8 has gone down and lan20 is now the active port in
APA.
# nwmgr -S apa -I 900 -v
lan900 current values:
Mode = LAN_MONITOR
Parent PPA = -
APA State = Up
Membership = 20,8*
Active Port(s) = 20
Ready Port(s) = -
Not Ready Port(s) = 8
Connected Port(s) = -
Polling Interval = 10000000
Dead Count = 3
After the DLA NIC is replaced with a new one, the Post Replace option of the olrad(1M)
command (olrad –R) can be used to resume usage of the card. To verify that the DLA NIC is
successfully suspended on the host and guest, the options of the olrad(1M) and ioscan
commands can be used.
184 PCI OLR support on VSPs