HP-UX vPars and Integrity VM V6.3 Administrator Guide

Memory chunksize : 65536 KB
Driver Mode(s) : STARTED ENABLED
AMR state : DISABLED
.
.
.
Table 33 (page 234) lists the dynamic memory characteristics displayed by the hpvmstatus and
hpvmmgmt commands.
Table 33 Dynamic memory characteristics
DescriptionSettingCharacteristic
No dynamic memory support.noneType
Dynamic memory is configured on the host, but the dynamic
memory subsystem on the guest has not started and reported
the implementation type.
any
Dynamic memory is implemented in a driver and does not use
Guest OS Online Add or Delete features.
driver
Dynamic memory is implemented using Guest OS Online Add
or Delete features.
OLAD
The lower bounds for ram_target and
ram_dyn_target_start.
valueM (for
megabytes) or
valueG (for
gigabytes)
Minimum memory
The target memory size of the guest, set using ram_target or
ram_dyn_target_start.
valueM (for
megabytes) or
valueG (for
gigabytes)
Target memory
The upper bounds for ram_target and
ram_dyn_target_start.
valueM (for
megabytes) or
valueG (for
gigabytes)
Maximum memory
The current memory size of the guest (usually equal to target
memory).
valueM (for
megabytes) or
valueG (for
gigabytes)
Current memory
A value for ram_target which can be used to reduce the
guest memory but allow the guest sufficient memory resources
to continue running a minimal workload.
valueM (for
megabytes) or
valueG (for
gigabytes)
Comfortable minimum
Size of physical memory in the VM presented to the guest OS.valueM (for
megabytes) or
valueG (for
gigabytes)
Boot memory
Amount of free memory in the guest.valueM (for
megabytes) or
valueG (for
gigabytes)
Free memory
Amount of memory in the guest allocated by user processes but
not locked. This memory is available for paging.
valueM (for
megabytes) or
valueG (for
gigabytes)
Available memory
A value between 0 and 100 used as an indicator of memory
deficit and paging. The higher the number, the longer the system
is in a memory deficit. A memory pressure value approaching
100 usually means the system is hung.
valueMemory pressure
234 Managing vPars and VMs using CLI