Installing and Managing HP-UX Virtual Partitions (A.02.01)

Problem with Adding Unbound CPUs to a Virtual Partition
Cause
Appendix B 165
There are now two unbound CPUs, but these CPUs are not the same
processors that were available at the time the partitions vpar1 or vpar3
were booted.
Problem is Encountered
At this point, if we attempt to add an unbound CPU to vpar3 using the
following command:
# vparmodify -p vpar3 -a cpu::1
the command will fail and return the error message:
vparmodify Error: “-a cpu::1”: One or more unbound CPUs
were not available when virtual partition vpar3 was
booted. You must shutdown the partition to add them.
Although two unbound CPUs are available, their hardware paths are
x03 and x04. But the kernel entries for vpar3 are x06, x07, and x08.
Therefore, the command will fail.
The Workaround: Reboot the Target Virtual Partition
Because unbound CPU kernel entries are created when the target
partition is booted, you can reboot the target partition so that kernel
entries created correctly reflect the available unbound CPUs.
In our example, if we want to add an unbound CPU to vpar3, we can
reboot vpar3:
vpar3# vparstatus
vpar3# shutdown -r
Paths of Bound
CPU(s)
x01
x02
x05 x06
x07
x08
Unbound CPU
Kernel Entries
x06
x07
x08
x06
x07
x08
(none)
Paths of
Unbound CPUs
unbound CPUs are now at x03 and x04