Installing and Managing HP-UX Virtual Partitions (A.02.01)

Managing Virtual Partitions
Ignite-UX Network Recovery
Chapter 3 61
1. From the BCH prompt, boot the hard partition using the Ignite-UX
server (assume the Ignite server’s IP is 15.xx.yy.zz):
BCH> bo lan.15.xx.yy.zz install
interact with IPL? N
2. From the Ignite-UX window, select "Install HP-UX".
3. Enter the network data using the data for the virtual partition that
owns the boot disk that is set as the primary path within
system-wide stable storage.
4. Select Recovery Archive Configuration -> Go
5. After this virtual partition is recovered, recover the remaining
partitions using the instructions in “Recovering a Virtual Partition”
on page 59.