Installing and Managing HP-UX Virtual Partitions (includes A.03.03)

Monitor and Shell Commands
Managing: Performing nPartition Operations
Chapter 5
128
Transition to run-level0 is complete.
Executing "/sbin/reboot-R ".
Note: If this is a partitionable system, the requested reconfiguration will not take place until
all the virtual partitions on this hard partition are shut down and the virtual partition Monitor
is rebooted.
Shutdown at 16:19 (in 0 minutes)
At this point, all virtual partitions have been shut down. The Monitor will reboot automatically. On the
console, we would see the following message:
All partitions have halted. System will now reboot for reconfiguration.
and the beginning of the boot process for the nPartition:
Firmware Version 21.3
Duplex Console IO Dependent Code (IODC) revision 2
--------------------------------------------------------------------------
(c) Copyright 1995-2002, Hewlett-Packard Company, All rights reserved
--------------------------------------------------------------------------
Cab/ Cell ------- Processor -------- Cache Size
Cell Slot State # Speed State Inst Data
---- ---- ------------ --- -------- ----------- ------ ------
0 0/0 Idle 0A 1000 MHz Idle 32 MB 32 MB
0B 1000 MHz Idle 32 MB 32 MB
1A 1000 MHz Idle 32 MB 32 MB
1B 1000 MHz Idle 32 MB 32 MB
2A 1000 MHz Idle 32 MB 32 MB
2B 1000 MHz Idle 32 MB 32 MB
1 0/1 Active 0A 1000 MHz Active 32 MB 32 MB
0B 1000 MHz Idle 32 MB 32 MB
1A 1000 MHz Idle 32 MB 32 MB
1B 1000 MHz Idle 32 MB 32 MB
2A 1000 MHz Idle 32 MB 32 MB
2B 1000 MHz Idle 32 MB 32 MB
Primary Boot Path: 1/0/0/3/0.6
Boot Actions: Go to BCH.
HA Alternate Boot Path: 1/0/0/3/0.6
Boot Actions: Go to BCH.
Alternate Boot Path: 1/0/12/1/0.8
Boot Actions: Go to BCH.
Console Path: 1/0/0/0/1.0
Putting an nPartition into an Inactive State & Other GSP nPartition Operations
1. If possible, gracefully shutdown all the virtual partitions within the target nPartition. For example:
keira1# vparstatus
keira1# shutdown -h
keira2# vparstatus
keira2# shutdown -h