HP Superdome 2 Partitioning Administrator Guide (5900-1801, August 2011)

Figure 20 Active/EFI prompt State of vPar
Getting a Console using the CLI
To access the system console of a partition using the command line, run the CO command. It can
be used either with the partition’s ID or without it as shown:
co
Partition Partition
Number Name
--------- ---------
1 nPar0001
2 nPar0002
2:1 nPar0002:vPar0001
Q) Quit
Select partition number: 2:1
----Log Snippet---------
----Log Snippet---------
Welcome to the Superdome 2 console
<use <Ctrl-b> to exit.>
Shell>
Alternatively, you can also use the CONNECT PARTITION command to connect to a partition.
connect partition 2
----Log Snippet---------
----Log Snippet---------
Welcome to the Superdome 2 console
<use <Ctrl-b> to exit.>
Getting a Console using the GUI
To access the system console of a partition using the GUI, select the Remote Console tab, and then
click on the Remote Serial Console link.
Booting to UEFI and preparing for Operating System installation 55