BIND 9.3.2 Release Notes (5900-2140, December 2011)

10. Select the BIND 9.3.2 depot under Download Software.
11. Save the BIND 9.3.2 depot in a local directory, for example, /tmp.
12. To verify that the BIND 9.3.2 depot is downloaded properly in the local directory, enter the
following HP-UX MD5 Secure Checksum command at the HP-UX prompt:
# md5sum <depot_name>
The result of this command must match the fingerprint provided in the Electronic Delivery
Receipt. If the result does not match, download the BIND 9.3.2 depot again.
NOTE: The HP-UX MD5 Secure Checksum software is not installed by default on the system.
It is available at:
http://h20293.www2.hp.com/
13. To install the BIND 9.3.2 depot, enter the following command at the HP-UX prompt:#
swinstall -s <fully_qualified_depot_source_path>
The swinstall window is displayed.
NOTE: Ensure that the DNSUPGRADE.PHNE_33766 product or the
DNSUPGRADE.PHNE_34226 product is installed before installing the
DNSUPGRADE.BindUpgrade product. If you have installed the PHNE_33766 or PHNE_34226
patch or any of its superseding patches, you need not install the DNSUPGRADE.PHNE_33766
or DNSUPGRADE.PHNE_34226 product.
14. Press the space bar to select the product that you wish to install.
IMPORTANT: Do not install Web release versions of BIND prior to BIND 9.3.2, after installing
the DNSUPGRADE.BindUgrade product.
15. Select Install in the Action menu. The Install Analysis window is displayed.
16. Select OK when the Status field displays a Ready message. The Install window is displayed.
The BIND 9.3.2 software installation starts. The swinstall command loads the BIND 9.3.2
files on to the system in approximately 3 to 5 minutes.
17. Select Done when the Status field displays a Completed message.
18. Select File->Exit to exit from the swinstall window.
The named daemon is preconfigured and starts after installation. The swinstall command
installs BIND in the /opt directory.
For more information on configuring and using BIND, see the HP-UX IP Address and Client
Management Services Administrator’s Guide at:
http://www.docs.hp.com/en/netcom.html#Internet%20Services
Verifying the BIND 9.3.2 installation
To verify whether the BIND 9.3.2 depot is installed successfully on your system, enter the following
command at the HP-UX prompt:
# swlist -l product <depot_name>
If BIND 9.3.2 is installed properly, the following output is displayed:
• On an HP-UX 11i v1 operating system
# Initializing...
# Contacting target "hostname"...
#
# Target: hostname:/
#
Installing BIND 9.3.2 13