HP-UX Mobile IPv4 A.03.01 Administrator's Guide

OKREQPHKICPFOKRTQEQPHKI
7UKPIOKREQPHKICPFOKRTQEQPHKI
Chapter 9
115
Using mipconfig and miproconfig
This section contains information about using mipconfig, the HP-UX Mobile IPv4
utility for configuring Home and Foreign Agents and about using miproconfig, the
HP-UX Mobile IPv4 utility for configuring Correspondent Nodes that support Route
Optimization. This section contains the following information:
• “Online Help” on page 115
• “Operating Modes” on page 117
— “Novice Mode” on page 117
— “Expert Mode” on page 118
— “Batch Mode” on page 118
• “Special Characters” on page 116
— “Line Continuation character (\)” on page 116
— “Exiting a command character (control-c)” on page 117
— “Deleting a parameter value character (!)” on page 117
Online Help
mipconfig and miproconfig have online help.
To get an overview of the configuration process, enter the following command at the
mipconfig or miproconfig prompt:
overview
To display a list of commands, enter ? (question mark) or help.
To get syntax information for a command, enter the following command:
? command_name
Alternatively, you can enter the following command:
help command_name
You can abbreviate the command name. For example, to get syntax information about
the configure node (c n) command, you can enter the following mipconfig command:
? configure node
Alternatively, you can enter the following command:
? c n
To get syntax and parameter (verbose) information for a command, enter the following
mipconfig command:
? -v command_name
Alternatively, you can enter the following command:
help -v command_name