HP-UX Mobile IPv4 A.03.01 Administrator's Guide

2TQFWEV5RGEKHKECVKQPU
5QHVYCTG4GSWKTGOGPVUCPF4GUVTKEVKQPU
Chapter 2
18
Software Requirements and Restrictions
HP-UX Mobile IPv4 requires the following prerequisite software:
• HP-UX 11i v2 or HP-UX 11i v3
• PHNE_28089 or later HP-UX 11i ARPA Transport patch.
• PHNE_28388 or later HP-UX 11i DLPI patch.
• PHNE_28444 or later HP-UX 11i netfmt patch. This patch is optional. This patch is
not required to install or operate the product. This patch allows netfmt to format
Mobile IPv4 packets. HP recommends that you install this patch. Without this patch,
netfmt will display Mobile IPv4 packets as hexadecimal values.
HP-UX Mobile IPv4 has the following software limitations and restrictions:
•The gated daemon must start before the HP-UX Mobile IPv4 daemon, mipd or
miprod, is started. If gated is restarted, then you must re-start the HP-UX Mobile
IPv4 daemon.
• HP does not ship systems with HP-UX Mobile IPv4 software pre-installed. HP does
not provide Instant Ignition for this product.