ONCplus B.11.31.09.01 Release Notes HP-UX 11i v3 (September 2010)

Installation Information
This section elaborates on the requirements and the procedures for installing ONCplus
B.11.31.09.01. It also includes information on verifying the installation of ONCplus B.11.31.09.01.
System Requirements
The following requirements are necessary for installing ONCplus B.11.31.09.01:
• Hardware Requirement: Itanium / PA-RISC
• Software Requirement: HP-UX 11i v3
• Free Disk Space: 65 MB
Installing ONCplus B.11.31.09.01
IMPORTANT: Back up your system before installing the product.
To install ONCplus B.11.31.09.01 on your system:
1. Login as root.
2. To check which version of ONCplus is currently installed on your system, run the following
command:
swlist | grep ONCplus
The output will be similar to one of the following twelve lines:
ONCplus B.11.31.09 ONC+ 2.3
ONCplus B.11.31.08 ONC+ 2.3
ONCplus B.11.31.07.01 ONC+ 2.3
ONCplus B.11.31.07 ONC+ 2.3
ONCplus B.11.31.06.01 ONC+ 2.3
ONCplus B.11.31.06 ONC+ 2.3
ONCplus B.11.31.05 ONC+ 2.3
ONCplus B.11.31.04 ONC+ 2.3
ONCplus B.11.31.03 ONC+ 2.3
ONCplus B.11.31.02 ONC+ 2.3
ONCplus B.11.31.01 ONC+ 2.3
ONCplus B.11.31 ONC+ 2.3
3. After you download the ONCplus_B.11.31.09.01.depot file, move it to the /tmp
directory:
/tmp/ONCplus_B.11.31.09.01.depot
4. Verify that the file has downloaded correctly using the swlist command as follows:
swlist -d @ /tmp/ONCplus_B.11.31.09.01.depot
If ONCplus is downloaded correctly, the output will include:
#
# Bundle(s):
#
ONCplus B.11.31.09.01 ONC+ 2.3
#
Installation Information 15