ONCplus B.11.31.09.01 Release Notes HP-UX 11i v3 (September 2010)

# Product(s) not contained in a Bundle:
#
PHCO_38048 1.0 libc cumulative patch
NOTE: You must specify the full path name of the source depot when you use swlist
and swinstall commands.
5. Run the following command to install the product on a stand-alone system:
swinstall -x autoreboot=true -s \
/tmp/ONCplus_B.11.31.09.01.depot ONCplus
NOTE: ONCplus includes kernel filesets. As a result, installing the product using the
swinstall command will require the system to be restarted after the installation is complete.
Verifying ONCplus B.11.31.09.01 Installation
To verify the ONCplus installation:
1. Run the following command to verify the software installation:
swverify ONCplus
If ONCplus B.11.31.09.01 is successfully installed, the following message is displayed:
Verification succeeded
2. To check which version of ONCplus is installed on your system, issue the following
command:
swlist | grep ONCplus
The output will be similar to the following:
ONCplus B.11.31.09.01 ONC+ 2.3
16 ONCplus B.11.31.09.01