ONCplus B.11.31.15 Release Notes (5992-5685, September 2012)

Table 1 ONCplus Enhancements and Software Defect Fixes (continued)
ONCplus VersionDescriptionCR ID
B.11.31.01The nfsstat command does not display access, close, and commit values
for NFSv4 when used with the -c or -s options .
QXCR1000585874
B.11.31.01Using kctune to change NFSv4 parameters causes a panic.QXCR1000585903
B.11.31.01Users cannot access an NFS mounted file system in PAM enabled Kerberos
systems.
QXCR1000585959
B.11.31.01The xdr_setpos function in libnsl.1 does not work properly.QXCR1000586940
B.11.31.01Writing from an NFSv3 client to a Red Hat Linux server fails with an “RPC:
Server can't decode arguments” error message.
QXCR1000587604
B.11.31.01The rpcbind daemon does not receive IPv6 multicast.QXCR1000588479
For more information on these defects and how they were fixed, see:
http://www2.itrc.hp.com.
Installation Information
This section elaborates on the requirements and the procedures for installing ONCplus B.11.31.15.
It also includes information on verifying the installation of ONCplus B.11.31.15.
System Requirements
The following requirements are necessary for installing ONCplus B.11.31.15:
• Hardware Requirement: Itanium / PA-RISC
• Software Requirement: HP-UX 11i v3
• Free Disk Space: 65 MB
Installing ONCplus B.11.31.15
IMPORTANT: Back up your system before installing the product.
To install ONCplus B.11.31.15 on your system:
1. Login as root.
2. To check which version of ONCplus is currently installed on your system, execute the following
command:
swlist | grep ONCplus
The output will be similar to one of the following twenty lines:
ONCplus B.11.31.14 ONC+ 2.3
ONCplus B.11.31.13 ONC+ 2.3
ONCplus B.11.31.12 ONC+ 2.3
ONCplus B.11.31.11 ONC+ 2.3
ONCplus B.11.31.10 ONC+ 2.3
ONCplus B.11.31.09.02 ONC+ 2.3
ONCplus B.11.31.09.01 ONC+ 2.3
ONCplus B.11.31.09 ONC+ 2.3
ONCplus B.11.31.08 ONC+ 2.3
ONCplus B.11.31.07.01 ONC+ 2.3
ONCplus B.11.31.07 ONC+ 2.3
ONCplus B.11.31.06.01 ONC+ 2.3
Installation Information 13