OSI Troubleshooting Guide, May 1997

Chapter 1 41
Interoperability Testing
Running X.25 Tests
Running X.25 Tests
1. From root, type osidiag and select “WAN X.25Tests.”
2. Create a result file.
3. Select “Connect.”
4. Enter the value for the remote X.121 address. This value is both the
address for the remote card and any subaddress concatenated into a
single decimal number.
5. Leave the X.25 Interface name unchanged.
6. For CONS change the protocol ID to the value 03010100. For CLNS,
change the protocol ID to 81. Press Done.
7. If the test status field says “PASSED,” proceed to “Testing Transport
Interoperability” on page 30.
If the test status field says “FAILED,” see “Interpreting X.25 Errors”
on page 42.