OSI Troubleshooting Guide, May 1997

Chapter 1 49
Interoperability Testing
Reason and Refuse Codes
(0xE7) Problem Accessing X.25 Subaddress of
Remote
Subaddress portion of X.121 from the OTS
routing table is incorrect or the remote is not
up.
Correct the routing table or
bring up the remote.
(0xE8) NSAP not Configured
Network address portion of the address
specified is not configured in the routing
table. (Not usually LAN)
Configure remote X.25 using
osiadmin.
(0xF0) Protocol Error Detected by Remote’s
Transport
Remote encountered an error decoding one o
the Transport PDUs sent by us.
Generate a trace and contact
your HP support
representative.
(0xF1) Protocol Error Detected by Remote’s Session
Remote encountered an error decoding one of
the Session PDUs sent by us.
Generate a trace and contact
your HP support
representative.
(0xF3) Invalid Address or Permanent Transport
Error
Usually returned when an invalid T- selector
or Network Address is given. Could also get
when remote stack is not running or the
remote’s X.121 address is not associated with
its NSAP.
Use osiconf to associate
X.121 address with NSAP.
(0xF4) Invalid Address or Permanent Session Error Check address specified, and
state of remote stack to
ensure it is running.
(0xF6) X.25 Unavailable or Transient Transport
Error
Verify that X.25 is up by
running x25stat operation.
(0xF7) Transient Session Error Verify status of remote stack.
Code Meaning Action