HP-UX 11i v3 Installation and Update Guide, February 2007 (Initial Release)

Updating to HP-UX 11i v3

Chapter 6 123

Step 6: Update In this step, the system proceeds with the actual update. At the Software

Selection tab type

i (install) to start the update process. After the update

has started, the system will typically execute a reboot.

Step 7: Verify Update After your system has completed its reboot, you will be prompted to

change media when needed. Use the following steps to verify that the

update completed successfully:

1. Verify that no errors were encountered before the update began by

viewing the contents of the log file: /var/adm/sw/update-ux.log.

You should see output similar to the following:

BEGIN update-ux

Command entered: update-ux -s

HPUX1:/release/11.31/HPUX11i-OE

NOTE: Output is logged to '/var/adm/sw/update-ux.log'

* Obtaining some information from the source depot. cp

/usr/lbin/swagent /var/adm/sw/tmp/update-ux compress

/var/adm/sw/tmp/update-ux/swagent uncompress

/var/adm/sw/tmp/update-ux/swagent.Z chmod +x

/var/adm/sw/tmp/update-ux/swagent

* Copying an SD agent from the source depot

/usr/sbin/swagentd -k /usr/sbin/swagentd -r

/usr/sbin/swcopy -s

HPUX1:/release/11.31/HPUX11i-OE -x

logfile=/var/adm/sw/tmp/update-ux/swcopy.log -x

autoselect_dependencies=false -x

enforce_dependencies=false -x mount_all_filesystems=false

-x register_new_depot=false -x uncompress_files=true -x

reinstall=true SW-DIST.SD-AGENT @

/usr/sbin/swagentd -k /usr/sbin/swagentd -r rm -f

/var/adm/sw/tmp/update-ux/orig_swagent.log rm -f

/var/adm/sw/tmp/update-ux/tmp_swagent.log

/usr/sbin/swagentd -k

update-ux.log (15%)