HP-UX 11i v3 Installation and Update Guide, February 2007 (Initial Release)

Updating to HP-UX 11i v3
Updating to HP-UX 11i v3
Chapter 6 127
NOTE Make sure to read “Supported Update Paths to HP-UX 11i v3” on
page 41 to ensure that you are updating your system from a supported
update path.
sw_spec Software selections support the same syntax as
the swinstall command plus the syntax
described in the selection syntax section below.
The following syntax is supported for sw_spec:
bundle[,
version ]product[.subproduct]
[.fileset][,version]!selectionbundle]/
[%match] pattern-matching-expression
where
version can be:
[,r <op> revision][,a <op> arch]
[,v <op> vendor] [,c <op> category]
[,q=qualifier][,l=location]
[,fr <op> revision][,fa <op> arch]
where
op can be:
=, ==, >=, <=, <, >, or !=
The = (equals) relational operator lets you
specify selections with the shell wildcard and
pattern-matching-expressions:
[ ], *, ?
The syntax !selection causes that selection to
be deselected even if it was listed on the
command line as part of other selections.
Table 6-4 Update-UX Commands (Continued)
Update-UX
Command
Description