HP-UX 11i v3 Installation and Update Guide, February 2007 (Initial Release)

Known Problems and Troubleshooting
Known Install and Update Problems
Appendix A144
Known Install and Update Problems
Table A-1 describes problems known to occur in the HP-UX 11i v3
release.
Table A-1 Known Install and Update Problems
Problem Description/Action
HP Service Control Manager
(SCM) not supported on
HP-UX 11i v3
The HP Service Control Manager (HP SCM) is not supported on
HP-UX 11i v3. If your system is running SCM, you must
migrate to HP System Insight Manager (HP SIM) version 4.2
BEFORE updating to HP-UX 11iv3; otherwise the update may
fail.
What To Do
Remove HP SCM before updating to HP-UX 11iv3. If you are
updating your system to HP-UX 11i v3 and HP SCM is installed
on your current system and you do not want to run it in the future,
you must remove the HP SCM product before you update to
HP-UX 11i v3.
Uninstall HP Servicecontrol Manager using the following
command: swremove –x enforce_dependencies=false ID
where ID is the product or bundle ID as shown in the following
example syntax:
swremove –x enforce_dependencies=false B8339BA
Remove the old product sub-directories by executing the following
command: rm -fr /opt/mx /etc/opt/mx
You can also remove the database for Service Control Manager,
mysql, by executing the following command: swremove mysql
You may also choose to migrate HP SCM version 3.0 to HP SIM
version 4.2 before updating to HP-UX 11iv3. You must be running
HP SCM version 3.0 to perform this update. If you are running an
earlier version you will need to update HP SCM to version 3.0
before updating to HP SIM version 4.2.
For more information on migrating from HP SCM to HP SIM
version 4.2 please see the HP Systems Insight Manager 5.0
Installation and User Guide.