HP-UX 11i v3 Installation and Update Guide, February 2007 (Initial Release)

Known Problems and Troubleshooting
Known Install and Update Problems
Appendix A146
NIS+ not supported on
HP-UX 11i v3
The NIS+ product is not supported on HP-UX 11iv3. If a system
is running NIS+, you must migrate to LDAP BEFORE updating
to HP-UX 11iv3; otherwise the update may fail.
The NIS+ to LDAP-UX migration tool uses NIS+ commands and
utilities for migration. Since the NIS+ commands and utilities
will not be available on HP-UX 11iv3, the migration tools will
not run on a system that has been updated to HP-UX 11iv3.
What To Do
Migrate NIS+ servers and clients to LDAP before updating to
HP-UX 11iv3.
Third-Party Product
Installation Scripts Fail to
Launch
For some third-party product installation scripts, dtksh is
required for scripts to launch license-acceptance dialogs for
Mozilla.
What To Do
• Either install CDE to enable the script to run as expected, or
execute /opt/mozilla/mozilla and manually accept the
Mozilla license.
Warning Message When
Performing swlist or
swverify
If you perform a swlist or swverify on the HP-UX 11i v3
software depots, you may encounter the following warning
message:
WARNING: [20002] Ignoring duplicate information for
the keyword “dynamic_module” at line.
What To Do
You can safely ignore this message.
Updating to HP-UX 11i v3
from HP-UX 11iv2 with
VxFS 5.0
If VxFS 5.0 has been used to create file systems with disk layout
version 7, those disks will not be readable by the VxFS 4.1 for
HP-UX 11iv3.
What To Do
Make sure you copy data from your DLV 7 file systems onto file
systems created at layout version 5 or 6 before updating to
HP-UX 11iv3.
Table A-1 Known Install and Update Problems (Continued)
Problem Description/Action