HP-UX 11i v3 Installation and Update Guide, February 2007 (Initial Release)

Cold-Installing HP-UX 11i v3
Cold-installing HP-UX 11i v3
Chapter 594
NOTE CDE is an optional product in HP-UX 11i v3. If you require it, you must
explicitly select the CDE bundle (CDE-XXX). This applies if you need
dtterm, which is located in CDE. For some localization situations,
dtterm is required, therefore CDE must be selected. CDE is listed in
Table C-3, “Optional Software,” in Appendix C, “HP-UX 11i v3 Software
Bundles,” on page 155.
Step 8. On the
Additional Software screen, you can deselect the software bundles
that are recommended and select optional software not installed by
default. Browse the product list, marking your selections, then press
Next
to accept your selections and proceed to the
Security Choices screen.
HP-UX 11i v3 offers several product categories from which you can select
additional software. In addition, each product category contains software
components that are marked as required, recommended, or optional
software components. See “Task 4: Selecting and Deselecting Software
Bundles” on page 96 for more information on these product categories
and required, recommended, and optional software components.
HP recommends that you do not deselect recommended bundles or
remove them from your system unless you know for certain that the
software contained in these bundles are not required for your operating
environment.