HP-UX 11i v3 Installation and Update Guide, February 2007 (Initial Release)

Cold-Installing HP-UX 11i v3
Cold-installing HP-UX 11i v3
Chapter 5 95
Step 9. On the
Security Choices screen, select the appropriate security setting for
your system based on the information in the section called, “Security
Considerations” on page 48. Please note that four security levels are
displayed. By default, Sec00Tools is selected.
Press
Next to accept your selection and proceed to the Pre-Install Disk
Information
screen.
Step 10. On the
Pre-Install Disk Information screen, identify which disks will be
overwritten during the install process. If you see a disk in the list that
you do not want included, back up to the root disk selection and choose
another disk; otherwise,
press Next to proceed to the Pre-Install Check
Information
screen.
Step 11. On the
Pre-Install Check Information screen, review any errors, warnings,
or notes. Warnings are simply informational. If any errors are displayed,
they will need to be resolved before you can continue the installation.
Press
Next to proceed to the System Summary screen.
Step 12. On the
System Summary screen, tab to Show Summary and press Enter to
to view a summary of how your system will be configured. If you see any
problems, or want to change any of your selections, back up to the
appropriate step, and make the needed changes; otherwise select
Finish
(at the bottom of the screen) to begin the cold-install process.
You can
Cancel at this time. If you cancel, you can start again .