Installation of VxFS and VxVM 5.1 SP1 on HP-UX 11i v3 March 2011 Operating Environment Update Release Whitepaper (April 2011)

On this page, select HP-UX 11i v3.
2. Use Ignite-UX to cold-install using the two depots referenced in the Ignite-UX
server INDEX configuration clause created in the previous section. In the
Basic tab, Configurations line, make your selection, such as “HP-UX
B.11.31_Mar2011_OE-Vx51”
3. Use the Ignite-UX interface to select the volume manager. In the Basic tab,
File System line, select the following:
VERITAS Volume Manager (VxVM) with VxFS
4. Use the Ignite-UX interface to select VxVM 5.1 SP1 and VxFS 5.1 SP1
software. In the Software tab, select the following:
Base-VxFS-51 Veritas File System Bundle 5.1 for HP-UX
Base-VxTools-51 VERITAS Infrastructure Bundle 5.1 for HP-UX
Base-VxVM-51 Base VERITAS Volume Manager Bundle 5.1 for HP-UX
5. Use the Ignite-UX interface to deselect the VxVM 5.0 and VxFS 5.0 software
if it is selected. In the Software tab, deselect the following:
Base-VxFS-50(OE)
Base-VxTools-50(OE)
Base-VxVM-50(OE)
B3929FB
6. Make any other configuration choices needed using the Ignite-UX interface,
and then select Go! to cold-install the client.
Confirming the Client
After the system boots, confirm the client has the intended software and
configuration. To confirm the software and the configuration, complete the
following steps:
1. Confirm the correct hostname. The output of the following command will
show the hostname.
# hostname
2. Confirm the correct OE version. The output of the following command will
display the OE version currently installed on the system: