VERITAS 4.1 Installation Guide (June 2006)

Removing Base-VXFS 4.1 and Base-VXVM 4.1
Chapter 438
* Software selections:
Base-VXVM,r=B.04.10.010,a=HP-UX_B.11.23_IA/PA,v=HP
VRTSalloc.VRTSALLOC,l=/,r=4.1,a=HP-UX_B.11.23_IA/PA,v=HP,fr=4.1,fa
=HP-UX_B.11.23_IA/PA
VRTSap.VRTSAP-FILESET,l=/,r=2.00.025.005,a=HP-UX_B.11.23_IA/PA,v=H
P,fr=2.00.025.005,fa=HP-UX_B.11.23_IA/PA
.
.
* Analysis and Execution succeeded.
NOTE: More information may be found in the agent logfile using the
command "swjob -a log <servername>:/".
======= 08/29/05 15:20:04 IST END swinstall SESSION (non-interactive)
(jobid=<servername>)
NOTE After removing the VERITAS packages, the system reboots.
Any errors that occur during the software removal process may be due to the following:
• System contains open volumes.
• Root disk is under Base-VXVM 4.1 control.
For more information, check the log file /var/adm/sw/swagent.log.
Removing Full VxVM (B9116BA)
To remove Full VxVM (B9116BA), run the following command:
# swremove B9116BA
The following output is displayed:
======= 08/24/05 16:56:49 IST BEGIN swremove SESSION
(non-interactive) (jobid=<servername>)
* Session started for user "root@<servername>".
* Beginning Selection
* Target connection succeeded for "<servername>:/".