VERITAS 4.1 Installation Guide (March 2006)

Installing Base-VXFS 4.1, Base-VXVM 4.1
Installing Base-VXVM 4.1
Chapter 4 23
If the OnlineJFS (B3929EA) package is successfully installed on your system, you will see the
following output:
======= 08/29/05 14:21:58 IST BEGIN swverify SESSION (non-interactive)
(jobid=<servername>)
* Session started for user "root@<servername>".
* Beginning Selection
* Target connection succeeded for "<servername>:/".
* Software selections:
B3929EA,r=4.1.001,a=HP-UX_B.11.23_IA/PA,v=HP
+ DiskQuota-Enh.DQUOTA-ENH,l=/,r=B.11.23.01,a=HP-UX_B.11.23_IA/PA,v=HP,fr=B.11.23.01,fa=
HP-UX_B.11.23_IA
+ FSCmdsEnh.FS-CMDS-ENH,l=/,r=B.11.23.01,a=HP-UX_B.11.23_IA/PA,v=HP,fr=B.11.23.01,fa=HP-
UX_B.11.23_IA
+ FSLibEnh.FS-CORE2-64SLB,l=/,r=B.11.23.01,a=HP-UX_B.11.23_IA/PA,v=HP,fr=B.11.23.01,fa=H
P-UX_B.11.23_IA
.
.
* The analysis phase succeeded for "<servername>:/".
* Verification succeeded.
NOTE: More information may be found in the agent logfile using the
command "swjob -a log <servername>:/".
======= 08/29/05 14:22:10 IST END swverify SESSION (non-interactive)
(jobid=<servername>)
Installing Base-VXVM 4.1
You can install Base-VXVM either in the non-interactive mode, or in the interactive mode.
Installing Base-VXVM 4.1 in the Non-Interactive Mode
To install Base-VXVM 4.1 in the non-interactive mode, run the following command:
# swinstall -x autoreboot=true -s <depot-path> Base-VXVM
The following output is displayed:
======= 08/29/05 16:26:02 IST BEGIN swinstall SESSION